This is just a "remix" of the original Holy Family by "makerwiz" (https://www.thingiverse.com/thing:1174448). The original thing was scanned from the actual physical model, but scanning was poor and characters looked like monsters -imo.

So I took the original image and gave it to some Chinese AI. With that single image the AI did a much better job, BUT baby jesus face is a bit off -chinese model 3.0 did a bit better job with faces, but for the back of the models model 2.5 did better. I'm including both.

EDIT: Just printed the "HolyFamily-3.0-500k.stl" and attached the images. Since 99% of the back of the figure was flat I decided to print it flat -laying on its back- but I had to sink it a bit on the bed since the hair of Joseph was sticking out a bit. With that change I reduced ~25% of the printing time, but it still required some small supports -I used tree supports and printed it using 20% of infill, and at 100 mm/s it took ~4.5 hours.