1/12
Model Overview & Print Notes
Summary
This is a jewelry stand/holder made to hold and show rings, necklaces, earrings and bracelets.
It comes in 5 different parts:
- A bottom support made for the rings
- A support for the bracelet rod that need to be strong
- A bracelet rod to hold the bracelet
- A necklace holder that holds both necklaces and earrings (support and brim are recommended for this piece)
- A hook (you need 8 pieces) to hold the necklaces
Depending of the printer you might need to cut the edges of the holes a little bit.
You will only need a scalpel to cut some of the edges and super glue
Assembly:
- Glue the bracelet Rod to its support
- Make sure that the notch can enter the hole of the bottom support
- Put a line of glue on top of the notch on the bracelet rod support for extra stability (not compulsory)
- Put each hook into the necklace holder (you might need to use the scalpel here)
- Make sure that the notch of the necklace support can enter the hole of the bottom support
Print Settings
Printer Brand:
Creality
<p class="detail-setting printer"><strong>Printer: </strong> <div><p>CR-10</p></div></p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>Doesn't Matter</p></div></p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Doesn't Matter</p></div></p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>200</p></div></p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>20</p></div></p> <strong>Filament:</strong> Geeetech PLA Silk White
💬Thingiverse Community Comments(1)
★Thingiverse Original Reviews