Model Overview & Print Notes

**Print it, pull it off the bed, slide it in.** **One piece, zero assembly.** Classic drawers print in one go with the handle built right into the front. No faceplates, no screws, no clips. Pop it off the plate and it is ready to go to work. **Every 270 size, one download.** 16 drawers, every width from 1W to 4W in 0.5H, 1H, 1.5H and 2H. **Made for the 270 collection.** The 270 drawers are made for extended build plates like the Prusa XL and Bambu H2D, for the long stuff that will not fit anywhere else. **Soft-close if you want it.** Snap in the magnet inserts with 6x2mm or 10x2mm magnets and the drawer pulls itself shut. **Classic or Decor?** Classic is the fastest way to fill a wall with drawers. Want swappable faceplates, fancy handles and labels? That is what the [MODULITH 270 Decor Drawers](https://than.gs/m/1171387) are for, and they fit the same cases. GEN2 is now MODULITH. Same system, same compatibility. The case is the building block: slide in drawers, add a shelf, or hang a door, and rearrange or expand anytime. ### WORKS WITH MODULITH 270 CASES Every drawer slides into the 270 case of the same size: [MODULITH 270 Cases](https://than.gs/m/1535458) ### DRESS UP THE SIDES Open case sides look even better with [MODULITH 270 Side Covers](https://than.gs/m/1619979). ### LET THE FREE PLANNER HANDLE THE DETAILS Not sure which drawer sizes you need? Build your layout in the free MODULITH Planner and it works out the parts for you, hands you a complete parts list with download links, and generates a step-by-step 3D assembly guide for your exact setup. 👉 [Open the free MODULITH Planner →](https://gen2planner.jerrari3d.com/?from=thangs&ref=modulith-270-classic-drawers-all) ### SIZES IN THIS DOWNLOAD - **1W to 4W:** 0.5H, 1H, 1.5H, 2H - 16 drawers, plus QuickLocks (print them in PETG), the Bi-Directional QuickLock, drawer stoppers and the 6x2mm and 10x2mm magnet inserts ### WHERE TO PUT THEM - **Under a table or shelf:** [rails](https://modulith.systems/catalog/under-table-rails/) screw in and the cases slide on - **On a desk:** the [MODULITH 270 Tabletop Starter Kit](https://than.gs/m/1253780) builds a freestanding stack - **On the wall:** the [Wall Mount Kit Lite](https://modulith.systems/instructions/wall-mount/) holds cases on almost any vertical surface ### PRINT SETTINGS - **Recommended filament:** PETG, PCTG, or PLA - **Supports:** None - **Perimeters:** 2-3 - **Nozzle:** 0.4mm - **Layer height:** 0.2mm Every part is oriented ready to print. The drawers include little helper disks for bed adhesion: peel them off by hand or turn them off in your slicer. See the **Instructions** tab for assembly details. ### SUPPORT MODULITH Become a member on my Thangs profile for member-exclusive models and early access. Every membership helps fund new MODULITH releases and free tools like the Planner.