This shelf is for Ryobi One+ tools. Easy storage and easy access. It is intended to be wall mounted. 

I have tested with 3 tools, the glue gun and the Inflator (air blower as seen in the picture).


It does NOT fit my drill, the Ryobi R18PDBL as this is a tad smaller in the battery compartment. Perhaps scaling it down a few % could help, but I will put up a separate mount for the drill. 

I also added a small tray for glue stick or other accessories. 

PETG and PLA should both work.

0.2 mm

4 walls minimum due to strength. 


Link to wall mount for the Ryobi One+ Orbital sander: https://www.printables.com/model/862794-ryobi-one-orbital-sander-wall-mount


EDIT: I added a test cutout of the battery plate. Can be printed thin with little infill to save material. This is to check for scaling and how it fits your tools. I did this because even though the batteries can fit a vast number of tools, there are variations between the One+ tools, and scaling might be needed.