A small stage lighting wrench for adjusting bolts on lighting clamps & yokes. The goal was to create a simple lighting wrench for adjusting state lights with the ETC C-Clamp at shows.

I wanted to make the wrench shorter than the TSA tool requirement of 7 inches and be small to fit in a Pelican case, so this is 5.16" (131mm) and a little less than ¾" thick (18mm).

Includes the following:

• 5/16" Square
• ½" Square
• ¼" Hex Bit Driver in the Tip
• ¼" Hex
• 3/8 Hex
• ½" Hex
• 5/8" Hex
• ¾" Hex

I printed in Polymaker PolyLite PLA Pro with 3mm thick walls, 3mm thick top and bottom, 40% line infill, and 0.2mm layer height. The wrench is surprisingly strong in the PLA Pro and I have no problem adjusting the bolts on a C-Clamp.