Furniture set for a complete living / dining room combo. This was part of an old project of mine where I implemented a stripped down version of the MakeItHome furniture arrangement algorithm in a solver in Houdini, these are the individual models used in that project. 

All models are orientated in their print orientation to be printed without any supports.

Tv and Tv_brace would need to be glued together for something more sturdy.

Print with 0-5% infill, 2-3 perimeters. Photo is printed at 0.28mm layer height, but for more detail, go finer.

Be careful when removing the table and dining chairs from the build plate, the legs are thin and with brittle filament will break off if you're not gentle.