This print is best printed in PLA or PETG (preferred), I printed this on the ender 3 v3 plus. The size of the screw might not fit and/or cause print problems so to avoid this, please print with slow speeds on the screw. This can support around 1.5 pounds which is enough for most needs. Please tell me any feedback to improve this print.  I used a 0.4 mm nozzle on this print. The print comes in three different sizes-large being for large mugs and thermoses, medium being for larger bottles and mugs, and finally small being for small mugs and cans. Here are the desired print settings:

Screw Print Settings - On Prusa Slicer

Brim - Yes 

Other supports - not needed

Print Speeds

Perimeter - 15 mm/s

Small perimeter - 15 mm/s

External perimeter - 15 mm/s

Infill - 15 mm/s

Solid infill - 15 mm/s 

Support Material (None)

Support Material Interface (None)

Bridges 15 - mm/s

Over Bridges - 15 mm/s

Gap Fill - 15 mm/s

Travel - 130 mm/s

First Layer Speed - 15 mm/s

Cup Holder (all sizes) Print Settings - On Prusa Slicer

Brim - Yes (peel away for screw to fit)

Perimeters - 100 mm/s

Small Perimeters - 100 mm/s

External Perimeters - 100 mm/s

Infill - 90 mm/s

Solid Infill - 60 mm/s

Top Solid Infill - 60 mm/s

Support Material - 90 mm/s 

Support Material Interface - 90 mm/s 

Bridges - 100 mm/s 

Over Bridges - 100 mm/s

Gap Fill - 20 mm/s

Travel - 200 mm/s

First Layer Speed - 70 mm/s

Speed Of Object First Layer Over Raft Interface - 50 mm/s