This detached house is a remix by minuber, which can be found at the following link: https://www.thingiverse.com/thing:6763801

I modified some parts of the house and also had to reconstruct some elements, as scaling up from N-scale to H0-scale caused some defects

Changes I made:

• The original model is only available in 1:144 (N-scale), so everything was adapted to 1:87 (H0)
• all windows were revised or newly designed
• on the building, I created one large door from two small patio doors and provided a corresponding door
• the terrace is included as a concrete variant (original) and a wooden variant with texture (I found it more attractive - see photos)
• the PV and solar system, as well as the heat pump outdoor unit, are completely redesigned
• I added roof tiles to the roof and redesigned the chimney (with two flues), as well as the roof windows
• the gutters and downpipes are also new
• unfortunately, I also had to remake the railing
• finally, my wife came and wanted flower boxes ;-)

Notes:

• I printed everything with a 0.4 nozzle. For the railing, a 0.2 nozzle might be suitable. The length of the railing may need to be adjusted
• the same applies to the heat pump
• I glued the roof windows with the wide surface facing up (i.e., upside down), which looks more realistic. A matte filament should perhaps be chosen here
• Basically, everything can be adjusted in size via the slicer
• the size of the house is approximately 17cm x 12cm x 9.5 cm (W/D/H)
• the recesses on the floors are intended for lighting by the original designer. I left it that way…