🌿 Pea Pod Organizer — Small Storage Inspired by Nature

Inspired by the way a pea pod holds its peas, this design turns three rounded “peas” into removable storage containers with individual lids, nestled in a matching pod-shaped tray.

Use it to organize beads, rings, paper clips, small screws, and other tiny essentials on your desk or craft table.

The design is lightweight and easy to print and assemble, with no glue or additional hardware required. Small internal contact pads help the lids stay securely fitted while allowing them to be opened by hand.

🖨️ Tested Printing Settings

The revised design was successfully printed on a Creality Hi using Hyper PLA. Lid fit and container placement were physically tested.

• Nozzle diameter: 0.4 mm
• Layer height: 0.16 mm
• First layer height: 0.20 mm
• Walls: 3
• Infill: 15%
• Nozzle temperature: 220°C
• Bed temperature: 60°C
• Outer wall and top surface speed: 80 mm/s
• Supports: Not required in the specified print orientation

🔧 Printing and Assembly

Print one tray, three container bases, and three lids.

Place the flat bottoms on the build plate, with the container and lid openings facing upward.
Allow the parts to cool completely. Place the containers in the tray’s circular seats and gently press the lids into place.
Print one Standard lid first to check the fit. If it is too tight, use the Lighter version; if too loose, use the Firmer version. Print the remaining lids using the version that fits best.
The lid variants are alternative fits, not separate assembly components. Fit may vary between printers and filament settings.

📏 Approximate Dimensions

• Tray: 188 × 66 mm
• Closed container: 45 mm diameter × 40 mm high

Print at 100% scale to preserve the intended fit.

📷 Images

The green cover is an AI-generated conceptual visualization showing suggested colors and uses. The white model photographs show the actual printed product.

Created for the Plant-Inspired Homeware design contest.