TOOLMAKER'S CLAMP

This toolmaker's clamp is perfect for smaller hobby work. Use it to hold small parts while you work on them.

PRINTING

Print the pieces as they are laid out in the last picture for the best results. I recommend 0.2mm layers, 3 walls, at least 20% infill, and a minimum of 1mm bottom and 1mm top layers. PLA works ok. PETG or ABS would be even stronger.

ASSEMBLY

1. Put the Main Screw through the Left Clamp. 
2. Slide the Retainer into the slot in the Main Screw and thread the Retainer Screw through the Retainer and into the Left Clamp.
3. Thread the Right Clamp onto the Main Screw.
4. Thread the Aux Screw into the Left Clamp.
5. The tolerances of the Main and Aux Screws are fairly tight so they might need to be threaded in and out of the clamps a few times to loosen up a bit.