Assembly Instructions

All the parts of the full moon mood light are cut into 4 pieces so it can be printed on a 256mm x 256mm print bed.
First glue all the parts of the inner ring, then glue on the pieces of the moon.
Then glue all the outer rings together and put in your LED strip (2 meters is enough) just behind the edge so it sits in front of the moon when put together (see picture); there is also a little cut-out to let the LEDs overlap so you can have a seamless ring of light (see picture).
Then you can glue the outer ring over the inner ring and moon.
On the backside of the inner ring there are 2 holes for hanging the moon with a small screw, one at the top and one at the bottom.
Mine is hanging straight with just the top one, but if you have any trouble with that, the bottom one is there to help you; just make sure you place them at the right distance.
As an extra tip, I like to add that I used a COB LED strip  and it gives a more beautiful light effect (see differences in picture).