Hey guys, since it's Easter, I decided to design something traditional, and it turned out like this. I'm very happy with the results.

It is an easy print; supports are optional. I've successfully printed it without them on the K1 Max, but I would recommend using them for maximum detail.

Optional - Furry Walls - Please check the print settings below.

Print Settings
Infill - 15%
Seam Position - Random
Supports - Under Chin - Recommend light tree / No Roof / No Brim
Ironing - Recommended but not necessary
Layer Height - 0.16mm (Can go lower, but not necessary)
Print Flat

Same Settings as Above
Fuzzy Skin Settings (Optional)
Infill - 20%
Fuzzy Skin - Contour
Distance - 0.8
Thickness - 0.2

These are basic settings for this model. It also depends on your printer, but I recommend the K1 Max.

Print Flat
Please do not sell my model. If you would like a commercial license, you can contact me at
https://www.facebook.com/iPrint3Ddesigns
or my personal profile
https://www.facebook.com/profile.php?id=61551609915138

Print Settings
Infill - 15%
Seam Position - Random
Supports - Under Chin - Recommend light tree / No Roof / No Brim
Ironing - Recommended but not necessary
Layer Height - 0.16mm (Can go lower, but not necessary)
Print Flat

Same Settings as Above
Fuzzy Skin Settings (Optional)
Infill - 20%
Fuzzy Skin - Contour
Distance - 0.8
Thickness - 0.2

These are basic settings for this model. It also depends on your printer, but I recommend the K1 Max.

Print Flat