Button hook

No support needed

I hope you like it. I printed it out in matte black and advise you to do that too because it is beautiful. Nozzle: 0.5 - 0.6 Layer Height: 0.16 - 0.2 Infill: 10-15% Top Layers: 6

Rubber band

You will need a rubber band that is 8 mm wide. It will be a tight fit but it works. It also works with a smaller width rubber band but it will be less clean.

How to mount

You can use a screw to mount it to the wall and glue the button and mount for a good permanent fit. They fit together without glue but there is a chance that it will fall off.

I made a tutorial video

Check out this video and you will see how I assemble it. And to know more about my work <3 video