Simple Trophy Base / Display Plinth — No Supports

Model Overview & Print Notes

Summary A simple trophy stand meant to be decorated by you. I kept ending up in the same situation: a finished print, a figurine or a medal sitting on a desk looking unfinished. With no desire to spend another evening modelling a pedestal from scratch, I made one base that fits most of my use cases. No branding, no texture, no theme. Just clean chamfered geometry that reads as "pedestal" from every angle and gets out of the way of whatever you put on top. I prefer the PEI-texture as top surface. Measurements: 106 x 106 x 50 mm Supports: None Infill: 5% gyroid Layer height: 0.2 mm Walls / perimeters: 2 Material: PLA Build plate: Textured PEI — this is the surface finish Orientation: As placed in the file — top face down on the plate Brim: Not needed (large flat contact area) Print time: ~2 hours Filament: ~71 grams Post-Printing <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/f1/f0/d3/65/2c/IMG_0323.JPG"></p> <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/d9/9a/1b/06/b1/IMG_0321.JPG"></p> <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/5d/54/04/dd/bf/IMG_0324.JPG"></p> <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/e0/bb/d1/86/3d/IMG_0322.JPG"></p> <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/8e/97/49/90/5f/IMG_0326.JPG"></p>