Flared Quilted Planter

Model Overview & Print Notes

This quilted pattern has been one of my most popular textures and it's now available on the newest version of my dovetail planters! I've also made a few improvements to the planter design itself: - The previous version used an inner pot that dropped in from the top, this new version uses a drainage tray insert that is held in place using a twist-lock mechanism - Custom supports are now included in the model so you don't have to mess with support settings - New wall mount that matches the flat bottom of the dovetail - Included a larger pot. Note that this will be much heavier than the small and medium sizes so use at your own discretion! Compatible with [The Vertical Rail](https://thangs.com/designer/LoftedGoods/3d-model/The%20Rail%20v2-1397922), [The Horizontal Rail](https://thangs.com/designer/LoftedGoods/3d-model/The%20Horizontal%20Rail-1515555), [The Tripod Rail](https://thangs.com/designer/LoftedGoods/3d-model/The%20Rail%20-%20Tripod%20Attachment-1463861), and my original [command strip wall mount](https://thangs.com/designer/LoftedGoods/3d-model/Updated%20Mounts%20for%20Wall%20Planters-1103659). The Command Strip mount is included in this file. The files for both versions of The Rail can be downloaded from the links above! ------------------------------------------------------------------------------------------ **Supports** Supports are needed for the flat underside of the dovetail on the planer, but they're already included in the model so you don't have to turn any support settings on. ------------------------------------------------------------------------------------------ **Scaling** The planters with dovetails cannot be scaled since this is designed to fit with my universal dovetail system. The tabletop planter can be scaled however you like. ------------------------------------------------------------------------------------------ **Orientation** - Pots and drip trays print upright with its bottom on the build plate - Drainage tray inserts print upside down - The wall mount prints flat with the sliding dovetail facing up ------------------------------------------------------------------------------------------ **Print Settings** - .2mm layer height - 15% grid infill | 15% gyroid infill for wall mount - 2 walls - Set bridge flow to 1.6 for drip tray and wall mount ------------------------------------------------------------------------------------------ **Filament** **[Bambu Lab Matte PLA](https://shrsl.com/4v5m0)** Colors I used: - Dark Green ------------------------------------------------------------------------------------------ **Hardware** - [#10 - #12 x 1-1/4" screws and anchors](https://a.co/d/0ckAHfX8) - [3M Medium Picture Hanging Command Strips](https://a.co/d/02Gke55r) Filament and non 3D printed items for this model can be found on my Amazon Storefront, linked here: https://linktr.ee/loftedgoods

Files (1)