Hinged foldable hood support, w/ball bearings, 2 models

Model Overview & Print Notes

2 versions here - printed fully interlocked - with ball bearings in the lower joint Nice mod for the hood if you need to print with vented chamber (i.e. PLA) BOM model 1 (fully printable, no ball bearing): m3 x 8 m3 heat sink insert m3 x 12 m3 hammer nut (or similar) BOM model 2 (w/bearings) m5 x 20 bolt m5 T-nut m5 nut or nylon nut m5 washer m3 heat sink insert m3 x 12 mm bolt (depends on the thickness of the panel) f695 x 2 (ball bearings)  

Files (2)