Ender 3 v3 se ke gantry support

Model Overview & Print Notes

UPD:  JAN - added models without led bar, without screen (for regular and hidden bolts)   Hello community! Like many of you, I was shocked by the weakness of the frame and made some attempts to fix it. Adding dampers under the printer - helped with noise Rotating spool - helped a bit, but was not a silver bullet Removing the spool out of the frame - IMHO did not help I even wanted to stop my experiments, but discovered a significant angle of the frame ( You should definitely check yours!) Also check Y axis rods! Screws weren't even touching rods. Replaced with a bit longer bolts So the solution was pre-defined: add metal gantry supports! I have found only one implementation and did not like it, so created my own. You will need: threaded shaft - 1 meter of M10 - you should divide it by 50cm m4 bolts and nuts drill your brand-new but wobbly printer - you do this on your own risk blah-blah-blah How to print? PETG! Supports needed 4-5 walls, 40-50 infill No airflow to get the model really strong print orientation: Mount tips: Start with right side as it is bolt-on to install  the left bottom plate must be located as mirrored right side. Use left frame side as anchor for measurements use double-sided tape to initially mount left bottom part, check dimensions Possible improvements: remove the screen part if you use Klipper you can use M8 shafts and change holes, but I strongly suggest to use M10 threaded rod top models contain a connection part for the light bar - remove it if not needed. But I am pretty happy with this kind of light Also, if you know other ways to improve stability, raise quality and want to share your experience - welcome to comments,

Files (9)