Retro Desktop PC Raspberry Pi case

Model Overview & Print Notes

This model is now outdated. Check out V2 here ! ----------------------------------------------------------------- Retro Desktop PC style case based on an old 286 PC I grew up with. Designed to fit a Pi 4B with a 3.5 inch HDMI MPI3508 LCD display.  In addition to the print you'll need: Raspberry Pi 4B 3.5 inch HDMI MPI3508 LCD display (such as this one ) HDMI flat flexible cable (such as this one ). I used D2 + A2 + 15cm cable from the link. 40 pin GPIO extension cable (such as this one ) 4x M2.5x5 screws for securing the Pi to the desktop base 4x M2.5x5 screws for securing the desktop case to monitor base 3x M2.5x8 screws for securing the desktop case to desktop base 2x M2.5x8 screws for the monitor Optional: Pi speaker expansion board (such as this one ).  All parts except the monitor connector should be printed with supports. I used eSun Bone White PLA but my options for a close matching beige were limited where I am.   OS Configuration notes: I followed this guide by @Hypn to get the Pi to boot into DOSbox with retro splash screen. I'm running DOSbox under Debian Bullseye (As of writing I couldn't get the custom splash screen to work under Bookworm). I used the following values in my /boot/config to get the output to fit the monitor: overscan_left=20 overscan_right=60 After installing the LCD-show display drivers , add the following to the [all] section in /boot/config to rotate the screen to the correct orientation: dtoverlay=tft35a:rotate=270   CHANGE LOG Dec 26 2023 Added link to V2 Added /boot/config line to rotate screen Added front panel sticker

Files (7)