Kinetic Sand Art Tabletop Enclosure

Model Overview & Print Notes

This enclosure is intended to be used with SCARA robotic arm: https://www.thingiverse.com/thing:5907176 or https://www.printables.com/model/475687-scara-mechanism-for-kinetic-sand-art Components: (1) Plexiglass - 1/4" (6.35mm) thick x 18" (457mm) diameter (top) (1) Plexiglass - 3mm thick x 388mm diameter (under sand) (0.5) Yd. White Flocking Velvet (spray glue to sand side of 3mm Plexiglass) (1) 2 Way Power Splitter, 1 Female to 2 Male 5.5 x 2.1mm Cable (1) LED Strip Light SMD 5050 RGB+44 Key Remote+12V Power Supply (1) 4 Pin 10mm RGB LED Strip Light Connector Extension Cable 1M (1) Lb. Extra Fine Sand or Baking Soda (1) Steel Ball 10-12mm diameter Hardware: (4) M5 x 16 Flat Head Screws (4) M5 Flat Washers (4) M5 Lock Nuts (2) M3 x10 SHCS (2) M3 Flat Washers (2) M3 Lock Nuts (1) M4 x 16 SHCS (1) M4 Flat Washer (13) M4 Hex Nuts (12) M4 x 10 SHCS (24) M3 x 10 SHCS (24) M3 Hex Nuts Print Settings Printer Brand: Prusa Printer:  I3 MK3S Rafts: No Supports:  Yes Resolution: 0.2 mm Infill:  20% Filament: Hatchbox PLA Various   Notes:   Legs_x5, Leg_With_Channel, and Mask_Coupler_x6 are printed vertically and should have a 5-10mm brim. The screw holes in the legs are skinned over to improve bridging at the hex nut features. Drill or clean out the holes before assembly. Base\_Segment\_A, B and C require small build plate supports beneath the vertical dovetail features. Base_Segment_C and Clamp contain features that are unique to the power splitter and LED controller that I used. Use the provided STEP file to modifiy the geometry to match your components and then create new STL's as required. Custom Section Completed Application       Category: Decor

Files (15)