HotWheels Brick Car Accessory 1A -- Short simple truck head

Model Overview & Print Notes

This is a clone of the Brickin' Delivery HotWheels Brick car, head part.    Notes For V2: Good plate adhesion required ( Brim + Gluestick ) Low Print speed ( 30mm/s recommended) No supports Estimated print time: 1 Hour       Notes For V1: Please find your tolerances (in Cura I used Horizontal Expansion, 0.05mm[PUT IT HIGHER]) (I put -0.02 in all walls when remaking it [total 0.04]) Lower print speed (I used 30mm, travel speed 50mm) Good plate adhesion (I used Brim, 25 line count)

Files (2)