Bike Mount Adapter for Garmin watch

Model Overview & Print Notes

Some notes:  Can you please leave a comment with your watch model to confirm if the design fits, I would highly appreciate it! :) Also, if the model you are looking for is not listed, I can adjust the design to any model if you are able to provide the measurements* below (see picture): 1: band width 2: pin diameter 3: pin outter edge distance 4: watch frame diameter *taking measurements with a caliper is recommended Description: This is an adapter that will securely snap fit onto the pins of your Garmin Watch. The adapter allows you to have your watch in front of you rather than your wrist so you can see your stats (distance, speed and time etc.) in real time as you cycle. The adapter has been designed with a standard garmin edge bike mount interface to twist lock onto your existing Garmin bike mount (the listing doesn't include the mount). At the moment, I have a model for: Instinct Fenix 5S/5/5X Fenix 6S/7S Fenix 6/7 Fenix 6X/7X Forerunner 935/945/955/965 Epix Gen2 Tips: I strongly advise to use plastics with a good layer adhesion and weather resistant. Nylon: this plastic is the best one (weather resistant, strong, high layer bond, etc..) however, it might be difficult to print (high temperature, warping) ASA: If you can smooth the surface with acetone (which fix the problem of poor layer adhesion), you can have really good results with this one, however not all printers can print this plastic. For acetone smoothing, I use a 1.5L tuperware with 50-100ml of acetone and leave it for 1h30-2h (I use flashforge ASA).  PETG is the easiest as most of printer can print and the layer adhesion is good

Files (9)