Chewing Gum Vault II (Print-in-place)

Model Overview & Print Notes

Eleven sheaths with a hinged flip-top lid that give ordinary chewing gum bottles a chic, textured look - from geometric grids to organic cell structures.  No assembly, screws, glue or tools required. Please don't scale this model. The snap fit is tuned to the bottle neck, so scaling will break the fit. Looking for the free version, then check  here . Have fun! Patterns # 01 Rectangle grid 02 Diamond holes 03 Honeycomb (Kikkō) 04 Herringbone 05 Hemp leaf (Asanoha) 06 Ocean waves (Seigaiha) 07 Flower of life 08 Seven treasures (Shippō-tsunagi) 09 Organic cells (periodic Voronoi) 10 Diagonal slots 11 Round holes Compatibility Tested with: Airwaves, 46-piece bottle Wrigley's Extra, same-size bottle Orbit, same-size bottle Print Settings Setting Value Layer height 0.15 mm Supports Support on build plate only Infill 15 % Material PLA, PLA+ Orientation Upside down (rotated 180° from its position of use), lid open Installation Remove the original lid from the gum bottle. Slide the sheath over the bottle from above. Press down until the sheath snaps into place. Press the lid shut. A wedge-shaped lip on the inner rim of the lid grips the outer edge of the sheath and keeps the lid closed. When the bottle is empty, pull the sheath off and snap it onto the next one.

Files (11)