Chewing Gum Vault I (Print-in-place)

Model Overview & Print Notes

A single print sheath with a hinged flip-top lid that gives ordinary chewing gum bottles a clean, minimalist look.  No assembly, screws, glue or tools required. Please don't scale this model. The snap fit is tuned to the standardized bottle neck, so scaling will break the fit. Looking for the chic version, then check  here . Have fun! Compatibility Tested with: Airwaves, 46-piece bottle Wrigley's Extra, same-size bottle Orbit, same-size bottle Print settings Setting Value Layer height 0.15 mm Supports Support on build plate only.  Style: Snug Top contact Z-distance: 0.26 mm XY-seperation: 300% Infill 15 % Material PLA, PLA+ Orientation Upside down (rotated 180° from its position of use), lid open Installation Remove the original lid from the gum bottle. Slide the sheath over the bottle from above. Press down until the sheath snaps into place. Press the lid shut. A wedge-shaped lip on the inner rim of the lid grips the outer edge of the case and keeps the lid closed. When the bottle is empty, pull the sheath off and snap it onto the next one.