Soap Pump Bottle Cap Adapter for Glass Bottles

Model Overview & Print Notes

Works fine with PLA like mentioned in the original model. Tested with Mrs. Meyer's soap pumps, but may be compatible with other soap pumps with the following dimensions: ~17mm OD upper pump body (attachment point of locking cap / chaplet) ~22mm OD gasket The pump needs to be disassembled at a minimum between the locking cap and the pump body / cap. Insert a plastic spudger or similar tool between the locking cap and the pump body and pry it up while moving around the perimeter. The locking cap can be left floating between the piston and the pump head. If you do additionally remove the pump head, be careful of a secondary small metal ball bearing that can fall out of the top of the piston (on Mrs. Meyers pumps). The pump should be assembled around the cap in the same order as it was from the factory, but with the cap swapped out. From top to bottom: Pump head Locking cap / chaplet Piston / stem Bottle cap Pump body Gasket Glass bottle Recommend to reassemble the pump (specifically attaching the locking cap back to the pump body) without the glass bottle to avoid risk of injury, as press fitting the locking cap back on requires significant force.  Softsoap pumps have interchangeable parts with Mrs. Meyer's pumps, but their gasket OD may not be compatible with this bottle cap / some glass bottles.

Files (1)