Download, slice and print this model in the MakerSpell app — available on Android and Windows. Get the app
Model Overview & Print Notes
Introduction: The dice case is fully 3D printed, no supports are needed. You need to glue the D&D letters in and a few letters in the inside and the rollsurface as well. The reason is only to achieve some nice multicoloured effects. Important: I had big trouble to print the upper and lower box piece. Either I had warping or after the finished print it was bend into the opposite direction after releasing it form the bed. The way I solved this issue: use a glass bed clamped to the heat bed use (a sh*t load of) adhesive spray bed temperature 30° to minimize the temperature difference Afterwards let it fully cool down. To get the print off will not be easy, but if you manage to do it carefully it is worth the trouble. Some further notes: How many pieces you need of each file is stated in the file name. You should print the following two coloured by switching the filament: Labeling Upper_Box_Labels Rollsurface It is intended to not glue the lables on the bottom in. You may customize them according to what you play and what need in the current situation. You can print the Upper_Box without supports, the DnD letters can be done using bridging. Last but not least, if you like the design, please consider a tip, I need some beers after this ;-)