Klipper Pressure Advance Tower V2

Model Overview & Print Notes

I prefer this model better than the original. Lightweight, fast, & easier to read. Print: 1 Bottom layer 0.2mm layer height 1 Perimeter 0 Top layer 0 Infill Set all speeds to 100mm/s, except the first layer speed. Use your default value. Important in Prusaslicer: Under cooling: Set to 0 "Slow down if layer print time is below" Otherwise 100mm / s cannot be achieved. And Turn off "Lift Z" , during retraction, so as not to falsely trigger the TUNING_TOWER COMMAND .... procedure. Continue the procedure. https://www.klipper3d.org/Pressure_Advance.html For Direct drive extruder, I prefer to use FACTOR = .01 , instead of FACTOR = .005 . The precision is good enough anyway, and the printing time goes twice as fast until you find the sweatspot.

Files (1)