Earphone Case with Clip for ES100

Model Overview & Print Notes

This model includes the sliding lid. Having printed the original user's model at 115%, I've found that at 115% it's only just big enough for my Moondrop SSP IEMs with the stock cable. As such I scaled the model up to 140%. When you slice it, remember that you're already at 140% even though it will read it as 100%. The clip on the back is 21mm across from the inside, which should be big enough for the ES100. Sandpaper should do the rest. I think the FiiO BT5 clip is skinnier than the ES100, so it could also fit in there. I also added a hole in the sliding lid. You can drill a hole in the case and tie a few pieces of thread together to keep the lid attached to the case to prevent loss. This version is otherwise the same as the original, I just added a simple clip to the side for attaching my ES100 portable bluetooth DAC/amp. You'll need supports for the clip to print properly. 20% infill No rafts/brims 0.2mm resolution. 4 hours on ultimaker 3 Category: Audio

Files (1)