Home Assistant Voice Preview Edition Enclosure

Model Overview & Print Notes

This model is the original enclosure for Home Assistant Voice Preview Edition optimized for 3D printing.  It's based on the official injection-molded parts but with some adaptation to avoid many supports : Home Assistant logo on the bottom enclosure is removed 3D screw threads instead of threaded inserts for the top enclosure Flat wheek Flat button   Before printing it, read the assembling/reassembling procedure on Home Assistant documentation website to avoid breaking parts of your device : Disassembling the enclosure guide Reassembling the enclosure guide   You will also need to bring some parts from the original device :  The PCB The speaker All the screws The rubber pads for the bottom enclosure The rubber lug for the button   You have multiple way to customize the device with different level of difficulties: Easy : replace only the top enclosure. You will not need to disassemble the PCB. Intermediate : replace the top enclosure, the bottom enclosure and the button. Hard : replace all the plastics part. You will need to full diassemble to device and unclip the wheel for the PCB   Here's the recommended settings to print the parts:  Top wheel: 0.12mm layer height, no support Top button: 0.12mm layer height, no support Mic switch: 0.12mm layer height, no support Bottom enclosure: 0.20mm layout height, support enabled Top enclosure: 0.20 layout height, no support

Files (5)