Handle for Sensor & Heater Connector (for Centauri Carbon Series)

Model Overview & Print Notes

For the Centauri Carbon Series. Make hotend replacement easier   When replacing the hot end, you normally need to carefully plug and unplug connectors located deep within the extruder using tweezers.    By installing this handle, the heater and sensor connectors are combined into a single unit, allowing you to connect and disconnect them quickly, safely, and easily without tweezers, thereby streamlining hot end maintenance.   Changes from the previous installmen rev.A: We have added new alignment guides and refined the shapes of certain details. rev.B: Following reports that the cover would not close, we have revised its design.

Print profiles

Files (8)