Rock Climbing Hold Set - Low Poly Incut Crimps

Model Overview & Print Notes

This is a set of 12 crimps, all with varying degrees of positivity. Each hold is hand modeled to be super comfortable on the wall. The top edges of each hold in this set ranges from roughly 20mm to 35mm in depth. I prefer to print these holds in PLA Matte. Use 3/8" Standard socket bolts to mount them! Typically, this is done with a corresponding 3/8" T-Nut. Each hold has an integrated slot for a stainless-steel washer for increased strength! Washers that I use these from Amazon: AMLOOPH Flat Washers 3/8"x3/16"   Using a layer height of 0.15mm, add a pause at layer 70. Once the print pauses, insert a washer into the integrated washer slot for each hold.   I print all 12 holds at once on my P1P. It takes around 10 hours to get to the pause when I add the washers. Then another 6ish hours to finish the print. Every hold has been set and tested in my local rock-climbing gym. The holds feel slippery when first printed, but the moment you use any climbing chalk on them they feel amazing (trust me haha) Happy climbing! :)

Print profiles