Silica Gel Container

Model Overview & Print Notes

Silica Gel Container: Keep filament dry for top 3D prints. Moisture shield for best results.   Make sure to choose the correct print profile!   Pressure-Fit Version is for Bambu spools only! Note that different materials have different outcomes. I used Bambu PLA Basic White.   Standard Version min. silica size 1.5mm Presssure-Fit Version min. silica size 1.65mm   Standard version holds: 50g/1.76oz Pressure-Fit version holds: 67g/2.36oz   Fill it just below the thread, leaving an air gap. This allows the lid to close properly, provides airflow, and lets the silica gel tumble freely.   Presssure-Fit Version: Step 1: Insert the container from this direction . If you insert it the wrong way, you may have trouble fitting it properly. Step 2: Insert the container bottom-first into the spool and press until it clicks into place. To remove, push from the opposite side. Dimensions (Standard): Wall thickness 1.5mm - slits 1.5mm Outer dimensions 50mm x 48mm   Dimensions (Pressure-Fit Version): Wall thickness 1.65mm - slits 1.65mm Outer dimensions 55mm x 60mm

Print profiles