Under Desk Drawer with clamp

Model Overview & Print Notes

Hello! My friend asked for underdesk drawer without screwing, so I've designed an organizer with a clamp, that holds organizer tight to the table. Model contains 10 plates, but I didn't try to print everything at once, so feel free to organize it differently.   Assembly is simple enough: 1. ShelfBase is combined with shields through screws 2. Shields at the back are also combined with backStoppers through screws 3. At the bottom shields are combined with stabilizers 4. Clamp contains two parts: screw and press. Screw is screwed into the designed hole and then press is attached to the end of the screw. 5. Insert drawers onto rails and you're done! Important note: PETG is not stiff enough, so I glued silicon picies onto parts touching table: ShelfBase and ClampPress. If you have TPU, I think it would suit better.

Print profiles