Costco HEB Garbage / Trash Bag Wall Mount

Model Overview & Print Notes

Hey Everyone! This is a useful and practical print, apparently I'm good at hiding things on the inside of cupboard doors. This solves the problem of those large boxes under your kitchen sink. We always buy the bulk pack to save a few coins but they take up a lot of space. Now we store 1 roll in the holder mounted to the inside of a cupboard door and the rest in the garage until needed. The 5 in holder has 2 holes and the 6.25 in has 3 for mounting that are recessed, countersunk, and reinforced with extra infill. The 5 in fits the HEB Texas Tough 50 count roll 13 gal tall kitchen size and the 6.25 in fits the Costco 100 count roll 13 gal tall kitchen size. This would be a handy storage tool in your shop as well.   Update: (larger 6.250 in Holder) I have received many positive comments out of the hundreds of prints saying the Costco rolls fit just fine in the old 6in holder. A couple people have mentioned needing to remove a few bags to fit correctly. I'm guessing that there is a slight variance in Costco's manufacturing. So, i increased the size to 6.25in and added another wall loop for extra strength.   Update: (THE BEAST 7 in ID.) Thank you all so much for the inspiring and kind comments. I even appreciate the few of you out of the thousands of prints that have mentioned having to remove a few bags from the Costco rolls so they will fit. Since most folks have said they are fine without, I just attributed it to Costco's manufacturing processes. Until now, we just considered the issue as BONUS rolls. I hear your feed back and take is seriously; therefore, I designed “THE BEST” to accommodate the bonus rolls. The inside diameter is a full 7 inches, I have modified the inner base with a larger radius, and increased both the wall thickness and infill for extra strength. Due to its size and strength requirements it does use more filament and takes considerably longer to print. For that reason I would suggest measuring a new roll of whatever size you are using, and decide on which holder fits accordingly.   Thank you everyone, I really appreciate your comments and support!   Print Specifications: 0.4mm nozzle 0.2 layer height 2-3 wall loops 5-15% infill no supports needed

Print profiles