Easy Cable Winder

Model Overview & Print Notes

Boost Me Your Boosts Helps Me Create More Free Models! Thank You Very Much! Easy Cable Winder available in 2 designs - Because Tangles Are for Headphones from 2003   Say goodbye to cable chaos and hello to smooth, organised vibes! This 3D-printable cable winder is your new pocket-sized superhero, rescuing cords from the evil clutches of knots and tangles.   Whether it’s charging cables, earbuds, or mysterious USBs you swear you didn’t own, this little guy’s got your back. Just wind, snap, and boom – tidy desk, tidy life.   Printing: 2 designs each on separate plate winder prints with supports IMPORTANT:   If you are not using my print profile and use STL files to slice it yourself make sure you open winder and lid as ONE OBJECT. It Should look like in the picture below:   Tested with Bambu Lab filaments: PLA-CF, Basic PLA, Matte PLA   Assembly and using:   Very simple 2 part design, put a cable in winder, make sure both cable ends are same length, line cable with 2 grooves on bottom part and then twist top part till it snaps, then wind the cable in. Done!   Check Out My Other Designs!

Print profiles