DJI Mini 2 (SE) Payload Tilt-Drop + Landing Legs

Model Overview & Print Notes

Boost Me Boost because I'm just getting started on designing and I spent a lot of time on this, also for points for the gift card. This is a tilt-based payload dropper designed for the DJI Mini 2 SE (also fits the Mini 2, and mini 4K) . It uses a simple gravity-driven ring system that slides side-to-side as the drone tilts, eventually releasing the payload — no electronics or wiring needed. Unlike other droppers, this one includes built-in landing legs , allowing your drone to take off from flat surfaces —no hand launch required. The model prints without supports , is lightweight (just 9g!) , and comes in two parts:   For best results, Attach as far back as possible — legs face forward due to support-free flat printing and place the payload in the back left position of the print (as shown in the image) . This makes takeoff more reliable for not slipping on the small indent in the print. Use a string length that keeps the payload close enough for takeoff pull, but far enough to avoid bottom sensors. A faster-than-normal takeoff is recommended to give a clean pull and avoid slipping. (Make sure you enable payload ) The dropper body (attaches to the drone) The sliding ring (moves down the stair-step track) Fun, useful, and super easy to print and use!   this is a short video to show it working    

Print profiles