Minimal Drawer Handle - 96 mm and 128 mm Hole Spacing - M4 - No Supports - Concept, not print-tested

Model Overview & Print Notes

A clean bar pull for furniture drawers and cabinet doors in the two most common hole spacings, 96 mm and 128 mm. - Size: 30 mm projection, 12 by 9 mm grip bar, rounded edges. - Mounting: two blind holes of 3,5 mm, 14 mm deep, for M4 screws (self-tapping) or cut an M4 thread. Drill out to fit heat-set inserts if preferred. - Prints upside down on the flat top of the bar; the gap under the bar is a short bridge, so no supports are needed. Status: CONCEPT, NOT PRINT-TESTED. Check screw length so it does not bottom out. Designed by Anton Klitin, CAD engineer (CadQuery, FreeCAD). Open to freelance CAD work. License: CC BY 4.0

Files (6)