Christmas lighting ornament - landscape in the forest

Model Overview & Print Notes

It is a Christmas Ornament that expresses the scenery in the winter forest. This Christmas Ornament light is made up of 3 layers. It is designed to be used as lighting by inserting LED tea light candles inside. You can use it as atmospheric lighting by inserting LED tea light candles and turning the outer layer with trees and deers to express your own forest. ※ The size of this design is minimal. A larger print will give you better results. ※ The assembly method is as follows. 1. Insert the innermost layer into the groove on the bottom piece, then screw it into place. 2. Then apply the middle layer and then the outer layer. 3. Finally, connect the top piece to the knob of the inner layer part by rotating it. 4. If you put an LED tea light candle inside, do the opposite, separate it, insert the light, and assemble it again in order. Printing on Ender 3 3D printer video ➪ When printing each layer, it is recommended to use a support or lower the printing speed to 1800mm/sec or less, as the tree branch may shake during printing due to thinness and the printing quality may not be good. We wish you a wonderful Christmas season with these Christmas decorations! Merry Christmas~ Largest part in printing, size = X 65mm, Y 65mm, Z 35mm, After full assembly size= X 65mm, Y 65mm, Z 80mm Design by GOODesign

Files (1)