I designed the F-18 Super Hornet for the theatrical release of the movie Top gun Maverick. I tried very hard to express every possible part. I pride myself on being the best 3D printed airplane design I've ever designed.

Printing may be a bit difficult because there are a few small parts, but if you finish it well, you will be very satisfied.

1. AAA batteries are placed in the front of the plane to prevent the plane from rolling backwards due to an imbalance in the center of gravity. Please prepare exhausted AAA batteries.

2. Before making, be sure to remove the custom support and assemble it.

Remove the support and cut off any remaining parts with a knife. Any leftovers will interfere with assembly.

3. When connecting the flaps, please connect the flaps after checking the shape carefully and matching them.

4. The hinge that folds the wing should be turned over so that the bottom side for printing is up and connected to the wing.

5. The lower part of the flap(rudder) of the vertical tail wing is slightly inclined. Before attaching with glue, please put it on and check it carefully.

6. The cockpit instrument panel slides in with a slight twist.

With this F-18 super hornet, we hope you will feel the touch of Tops gun Maverick once again.

※ This is not a toy to play with, but a model for display. We recommend that you handle it with care. ※

Go to see F/A-18E Super Hornet Armament set

Go to see F/A-18E Super Hornet Display Stand

1 : 48 Scale

Largest part in printing, size = X 199mm, Y 122mm, Z 140mm, After full assembly size= X 274mm, Y 382mm, Z 100mm

Total Build time : 61h / Plastic weight : 230g

Design by GOODesign