Researcher's stand

Model Overview & Print Notes

I offer you this telescope finder holder with a vixen base. It is ideally made for a 32mm diameter finder but no more. The principle is to wedge the front of the finder with a bolt and adjust it at the rear with two points of support at 120°, the third point resting on a compression spring. I printed it in 33% PET-G with a thickness of 4 lines. It needs to be printed with supports. You will need : - 3 M5 nuts - 3 M5x20 hex head bolts - 1 M5x40 countersunk bolt - 1 ~10mm high and ~8mm diameter spring NOTE : The STL of the bracket is very slightly different from the one in the photos. The nut locations are inside the rings, which makes more sense. You'll still need to glue them in. ## 3D Printing Settings

Files (2)