Sonic

Model Overview & Print Notes

sonic, the supersonic heron. "Run this way, run that way, you can't catch me!" This is a model I had originally made for a simple 3D rendering, but the son of a friend found it nice and asked if I could print it, so here it is. I reworked it to be printable relatively easily, there is a lot of cutting because I thought it could be molded, but in the end it facilitates the printing and it minimizes the waste of resin in case of failure. I made it so that it can be printed on a resin printer with a 5.5 inch screen. Feel free to comment on my model or tell me if things are not going well, I am here to offer you models well finished, I always make sure to test my models before offering them but I am not immune to miss a defect. WARNING! in the pack there is an assembled model of Sonic, it is not intended to be printed, it is just a showcase to be viewed on the site! ## 3D Printing Settings nothing special, the base and head are massive and deserves to be hollow to limit the effect of suction. The joints are a little loose to facilitate the assembly, I also added some detouring so that we can mount the figure correctly. The figure with its base is about 14 cm high, it is possible to increase the scale a little, but the head takes a lot of space and I do not like to print too close to the edges.

Files (11)