Ragnarok RC Jet Boat Closed Lid

Model Overview & Print Notes

German: We offer a closed deck for the Ragnarok RC jet boat from M-Jet-Development ... the boat itself can be found here: https://www.cgtrader.com/free-3d-print-models/hobby-diy/other/ragnarok-3d-printable-rc-jetsprint-boat This requires 8x M3x08 screws and 7x M3x16 screws ... and glue Otherwise, the original deck frame from the Ragnarok is required for the deck. Namely : 2x Deck_frame_bar_engine.STL 1x Deck_frame_bar_left.STL 1x Deck_frame_bar_right.STL English A closed deck for the Ragnarok RC jet boat by M-Jet-Development is being offered. The boat itself can be found here: https://www.cgtrader.com/free-3d-print-models/hobby-diy/other/ragnarok-3d-printable-rc-jetsprint-boat Additionally, you will need 8x M3x08 screws and 7x M3x16 screws, as well as glue. For the deck, the original deck frame from the Ragnarok is required. Specifically: 2x Deck_frame_bar_engine.STL 1x Deck_frame_bar_left.STL 1x Deck_frame_bar_right.STL Update 09/23/24 ... ragnarok_lid2.stl ... Changed an edge from below so that you can press without support ... and increased the screw position at the rear, that was a bit tight for mother of the rangnarok ## 3D Printing Settings

Files (6)