Fishing Hooksetter with 3 different Rod Holders

Model Overview & Print Notes

I found this and thought I could make one and the rod holder. So I did. I now use this when I go fishing at Henry Hagg Lake in Gaston, Oregon. I made a rod holder for the bench because if there is a table near the lake you can use the bench rod holder and have it right next to you. Seconds count when you are fishing. You will need to buy: 1) One or Two, 3 feet long, 3/8" (10 mm) wooden dowel(s). 2) String or small rope. 3) The bottom center 3/8" (10 mm) wooden dowel is 10 inches long. I added different height hooksetters: 4mm, 3mm, 2mm My rod uses 2mm. I added a extension for the bottom for lake shore fishing. Check out the images. You will need to print 2 (two) "Hooksetter bottom angle.stl". One for the left side and one for the right side. I added an rod holder to fix over the Eagle Claw Large Wire Rod Holder. I added the image here so you know what one will fix. You can use this for shore fishing or ice fishing. Fishing Hooksetter Bench Setup: https://www.youtube.com/watch?v=9lk_ARgveX0 Here is a video of it. Not mine video but a video I found to show you how to set this up and use it. https://www.youtube.com/watch?v=hzG8eCv2ag4 ## 3D Printing Settings The filament I used is PETG. Resolution: 0.2, Infill: 90.

Files (11)