Bracelet Stamp Pack #1 - FDM Leather Stamping Tools

Model Overview & Print Notes

A pack of decorative bracelet/nameplate-style leather stamps designed for FDM printing and press stamping into damp veg-tan leather. This set includes multiple narrow banner-style designs sized for bracelet work, cuffs, straps, bookmarks, small panels, and leather test strips. These stamps are made with bold raised artwork intended for practical leather pressing rather than fragile display detail. They are useful for leatherworkers who want repeatable patterns without hand-tooling every line. Best used with: - Damp veg-tan leather - Arbor press, shop press, drill press, vise, or clamp press - A flat backing plate or plywood sandwich - Test scraps before final work The models are decorative leatherworking tools. ## 3D Printing Settings Recommended FDM print settings: - Material: PLA or PLA+ - Nozzle: 0.4 mm or larger, I use 0.6 - Layer height: 0.16 mm - 0.24 mm - Infill: 100% - Walls/perimeters: 4 - 6 - Top/bottom layers: 5 - 6 - Supports: Not required - Print orientation: Flat on the back/base of the stamp - Bed adhesion: Brim optional For stronger press stamps, use higher wall count and higher infill. PLA+ is recommended if you plan to use firm pressure. Leather use instructions: 1. Case/dampen veg-tan leather evenly. 2. Let surface moisture settle before pressing. 3. Place the stamp face-down on the leather. 4. Press with steady, even pressure using a vise, arbor press, drill press, or clamp setup. 5. Hold pressure briefly, then release straight up. 6. Always test on scrap leather first. Avoid hammering directly on thin printed stamps. For best results, press evenly with a flat plate. Results may vary depending on leather thickness, moisture level, printer calibration, and pressure used.

Files (10)